Skin Care

Mineral vs Chemical Sunscreen: How to Pick and Use the Right One

Mineral vs Chemical Sunscreen: How to Pick and Use the Right One

Woman in a white linen shirt holding two plain white sunscreen tubes on a sunny terrace, next to the title Mineral vs Chemical Sunscreen: How to Pick and Use the Right One.

Mineral and chemical sunscreens both protect when you apply enough and reapply on time. Here is how each works and how to choose between them.

Quick answer: Mineral sunscreen uses zinc oxide, titanium dioxide, or both, while chemical sunscreen uses other active ingredients, and both can protect your skin when you use them well. The best choice is the broad-spectrum, water-resistant, SPF 30 or higher formula you will actually wear every day, in the right amount and reapplied on time.

QuestionQuick answer
Mineral (physical) filtersZinc oxide and/or titanium dioxide; also called physical sunscreens
Chemical filtersAny active ingredient that is not zinc oxide or titanium dioxide
Who may prefer mineralPeople with sensitive skin and parents choosing for children
Amount for the faceAt least 1 teaspoon, per the AAD
ReapplyAt least every two hours, and after swimming or sweating

What is the difference between mineral and chemical sunscreen?

The difference is the active ingredient listed on the label. The American Academy of Dermatology (AAD) says that if the active ingredient is titanium dioxide, zinc oxide, or both, you have a physical sunscreen, also called a mineral sunscreen. If it contains neither, you have a chemical sunscreen.

Some products are hybrids, which contain one or more active ingredients from each group. To see which kind you have, look at the "Active Ingredients" section on the container.

How does each type protect your skin?

According to the AAD, whether a sunscreen is chemical, physical, or hybrid, it forms a protective layer on your skin that absorbs the sun's rays. Physical sunscreens also reflect some of the sun's rays in addition to absorbing them. In daily life, the practical result is the same: a sunscreen that is broad spectrum, SPF 30 or higher and water resistant helps protect against sunburn, early skin aging and skin cancer.

What does FDA say about mineral and chemical filters?

FDA regulates sunscreens as over-the-counter drugs, and its review of filters is still in progress. FDA states that its review found sufficient safety data on zinc oxide and titanium dioxide to support a proposal that sunscreens with those ingredients are "generally recognized as safe and effective" (GRASE). That is a proposal and is not yet final.

For a group of other filters, including avobenzone and oxybenzone, FDA proposed that they are not GRASE because they require additional data. FDA is clear that this proposal "does not represent a conclusion" that those ingredients are unsafe, and it says it will address the remaining proposals in a future order. In practical terms, FDA's own sunscreen advice is to choose a broad-spectrum product and use it as directed. Rules can change, so check FDA's sunscreen pages if you want the latest status.

Which type might suit you better?

Both types protect, so choose by how your skin feels and how the product wears. The notes below are a mix of AAD guidance and styling advice, and the styling notes are labeled.

  • Sensitive skin: The AAD says dermatologists recommend physical (mineral) sunscreens for people with sensitive skin.
  • Babies and young children: The AAD notes that sunscreens with zinc oxide or titanium dioxide, or special sunscreens made for infants or toddlers, may cause less irritation. Shade and clothing come first, and a pediatrician is the right person to ask.
  • White cast on deeper skin tones: The AAD says tinted sunscreen that matches your skin tone can help you avoid the white residue, or "cast," that some sunscreens leave on your skin.
  • Dark spots: The AAD adds that a tinted sunscreen with iron oxide better protects your skin from developing dark spots, because iron oxide protects against the sun's visible light.
  • Under makeup (styling advice): Lightweight lotions, gels and fluid formulas often sit more smoothly under foundation, while thicker creams can feel heavier. Try a new sunscreen on a day at home before an event. If you like a skin-like finish, our guide to serum foundation shows how to layer base makeup over skincare.
  • Around the eyes: The AAD says sticks are good to use around the eyes.

How do you apply sunscreen step by step?

Use enough, apply it early and keep up with reapplying. These steps follow the AAD and FDA.

  1. Check the label. Look for broad spectrum (protects against UVA and UVB), SPF 30 or higher, and water resistance.
  2. Apply before you go outside. The AAD says it takes approximately 15 minutes for your skin to absorb the sunscreen and protect you.
  3. Use enough. At a minimum, most adults need about 1 ounce, roughly a shot glass, to cover skin not covered by clothing. For the face, use at least 1 teaspoon, about the amount needed to cover the length of your index and middle fingers.
  4. Cover every exposed area. That includes your neck, face, ears, tops of your feet and legs. For hard-to-reach areas such as your back, ask someone to help or use a spray. With thinning hair, apply sunscreen to your scalp or wear a wide-brimmed hat.
  5. Protect your lips. Use a lip balm or lipstick with an SPF of 30 or higher. Our guide to lip sunscreen covers this in more detail.
  6. Reapply. Reapply at least every two hours, and more often if you are swimming or sweating. FDA notes that no sunscreen is fully waterproof, and that water-resistant labels must state whether protection lasts 40 or 80 minutes.

FDA advises that sprays should not be applied directly to the face. Spray into your hands first, or choose a lotion, cream or stick for your face, and follow the directions for the product form you have.

What to look for when you shop

  • Broad-spectrum label: FDA says broad-spectrum sunscreens help protect against both UVA and UVB radiation.
  • SPF 30 or higher and water resistance: This is the AAD recommendation for everyone.
  • Active ingredients: Zinc oxide or titanium dioxide means mineral; anything else means chemical; a mix means hybrid.
  • Tinted formulas with iron oxide: Useful for deeper skin tones and for dark spots, per the AAD.
  • Form that fits your routine: Lotion or cream for the body, stick for around the eyes, a light fluid or gel for under makeup (styling advice).
  • Fragrance-free or sensitive-skin labels: Helpful if your skin reacts easily; patch test first.

What to expect

Sunscreen protects only while it is on your skin and at the right amount, so expect to reapply through the day rather than rely on a single morning layer. It helps reduce your risk of sunburn, early skin aging and skin cancer, but the AAD says sunscreen alone cannot fully protect you. Pair it with shade, sun-protective clothing, a wide-brimmed hat and sunglasses with UV protection. The AAD adds that you should apply sunscreen every day on skin not covered by clothing if you will be outside, because the sun emits harmful UV rays year-round.

If vitamin C is part of your morning routine, our vitamin C serum guide explains how to layer it under sunscreen.

When to see a professional

Patch test any new sunscreen on a small area of skin before using it widely, and stop using it if you notice stinging, burning, a rash or swelling. If a reaction continues, see a dermatologist. A dermatologist can also check any new, changing or unusual spot on your skin. Ask a pediatrician about sun protection for babies.

FAQ

Is mineral sunscreen better than chemical sunscreen?

Neither is better in every case. Both can protect when they are broad spectrum, SPF 30 or higher and water resistant, and when you apply enough and reapply. The AAD says dermatologists recommend mineral sunscreens for people with sensitive skin.

Can sunscreen leave a white cast?

Some sunscreens leave a white residue, or cast, on the skin. The AAD says a tinted sunscreen matched to your skin tone can help avoid it, and a tinted formula with iron oxide also helps protect against dark spots.

How much sunscreen should you put on your face?

The AAD says to use at least 1 teaspoon on your face, which is about the amount needed to cover the length of your index and middle fingers. Rub it in thoroughly and include your neck and ears.

How often should you reapply sunscreen?

FDA and the AAD both say to reapply at least every two hours, and more often after swimming or sweating. Check the water-resistance time on your label.

Sources

  1. Sunscreen FAQs (American Academy of Dermatology)
  2. How to apply sunscreen (American Academy of Dermatology)
  3. Sunscreen: How to Help Protect Your Skin from the Sun (FDA)
  4. Questions and Answers: FDA's regulatory actions on over-the-counter sunscreen (FDA)

Written by Skin Care Desk

The Skin Care Desk is the BeautynFacts editorial team for skin care guides. Every guide is rewritten for today's readers and checked by our Fact-check Desk against the sources listed at the end of the guide.

Reviewed by Fact-check Desk

The Fact-check Desk checks every BeautynFacts guide before it is published: each claim against the cited sources, plus safety notes and when to see a professional.